Silhouette Cameo Pro MK-II

Accuracy

Updated Chassis

Cutting accuracy has been improved due to Silhouette’s New Architecture. Updated chassis for improved carriage stability and more accurate cutting. The new belt drive minimizes deviation and vibration.

Supreme Curring Proficiency

CAMEO PRO MK-II introduces the highest cutting force. The force of Tool Holder 1 is capable of 300gf. This is an improvement of approximately 143% over the previous model. 

Adaptive Sensor

The CAMEO PRO MK-II can adjust the sensitivity of the scanning sensor depending on the material surface. This increases the ability to properly scan registration marks on materials with a lustrous surface, such as metallic, shiny, or glittery, which the CAMEO PRO MK-II can now scan.

Four-point Registration Mark

Four registration marks are now supported. Correction in the vertical and horizontal directions is now possible, so that even if a design is distorted in printing, the distortion can be corrected, and the design can be cut.

Productivity

Unrivaled Speed

The maximum speed is now 400mm/s. This is an improvement of approximately 133% over previous models. The larger the material, the more effective.

Dual Cross Cut

Both auto crosscut and manual cut are provided. You can cut straight through the material at any desired position and immediately move on to the next project.

Repeat Job

Repeat a previous job at the touch of a button on the machine. When a repeat job is enabled, the load button flashes. If you press and hold this button for more than 3 seconds, the same cuts as before will be made.

Operability

Improved Visibility

Pinch rollers have been modified to improve visibility. The position of the material and roller is now easier to see, making it easier to accurately set the material.

Support Roller

There are now five support rollers instead of the previous two. Material can be conveyed more consistently.

Emergency Stop

It will now be possible to immediately stop a cut job if a major problem arises without losing power to the machine or having to disconnect it.

Versatility

More Material Sizes

New material sizes or materials that are slightly larger or smaller than the standard sizes can now be accommodated. The support rollers can be removed so that materials from 5″ to 24″ can be set without mounts.

Power Carriage

The power carriage of the CAMEO PRO MK-II opens up new creative possibilities by powering specialty tools. The addition of cutting edge tools like the heat pen, embossing tool, and pen holder enables an exponential increase in the range of projects that can be created.

Quiet Operation

With an ultra-quiet operating noise, users can use the machine at any time and place.